Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trusted Duct Repair & Sealing for Sunset Park Homeowners
Leaky ducts waste money quietly. A gap the width of a pencil along a trunk line can pull dust, humidity, and unconditioned air into every room it feeds, and in Sunset Park’s older rowhouses and converted brownstones that gap is often hidden above a drop ceiling or inside a closet chase. That’s the problem we fix. Our technicians have up to 9 years of experience tracing air loss back to the joint, seam, or crushed run that’s causing it, and we carry the mastic, mesh, and flex materials to close it on the same visit we clean. We work from professional-grade Rotobrush and Nikro extraction equipment, not shop vacuums, so the diagnosis and the repair happen together instead of getting split between contractors. If you’re seeing dust streaks at the registers or a room that never quite heats, call (844) 351-1795. Same-day repair is often possible when you call early.
What Our Duct Repair & Sealing Service Includes
Duct repair isn’t one job. It’s a set of specific fixes, and which one you need depends on what your system is made of and where it’s failing. Here’s what we handle.
Duct Sealing
Sealing means closing the gaps between duct sections, at the boots where the duct meets the register, and along every seam that’s opened up over time. You need it when a room gets noticeably less airflow than the rest of the house or when your energy bill climbs without a change in how you heat and cool. We seal those joints with mastic and mesh rather than tape, because tape fails at the temperature swings a forced-air system produces.

Flex Duct Repair
Flex duct is the silver, ribbed line you’ll see running through attics and joist bays. It’s easy to install and easy to damage: a kink, a sag, or a tear at a connection point can cut airflow to a whole room. We straighten runs that were installed with too tight a bend, reconnect sections that have pulled loose, and replace lengths that are torn or crushed beyond repair.

Metal Duct Repair
Sheet metal duct is durable but not indestructible. Sections separate at the joints, seams open, and screws back out over the years, especially in basements and mechanical closets where vibration is constant. We reseat separated sections, close open seams, and rebuild the connections so the trunk line holds pressure the way it was designed to.

Duct Insulation
Ducts running through an unconditioned attic or crawl space lose heat before the air ever reaches your rooms. Insulation wraps those runs so the air arrives at roughly the temperature it left the equipment. We replace insulation that’s compressed, torn, or missing entirely, which matters most on the longest runs to the far end of the house.
Mastic Sealant
Mastic is a brushable sealant that bonds to metal and flex alike and stays flexible as the system expands and contracts. We use it on every seam we close because it outlasts both foil tape and duct tape, which dry out and peel within a few seasons. It’s the difference between a seal that holds for years and one that fails by next winter.
Air Leak Repair
Air leak repair starts with finding the leaks, and most aren’t where homeowners expect. We trace the system from the equipment to the furthest register, checking joints, boots, and any place the duct passes through a wall or floor. Once we know where the loss is, we close it with the right material for that spot rather than a single blanket fix.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Brands We Service for Duct Repair & Sealing
We work with Honeywell and Aprilaire air quality components regularly and know where each one tends to wear. Honeywell filtration cabinets and bypass humidifiers mount directly to the ductwork, and the seams and gaskets around those connections are common leak points that a general duct cleaning skips right past. Aprilaire media cabinets and dehumidifier tie-ins have their own mounting details, and resealing around them properly takes a bit of care so you don’t disturb the equipment itself.
Our cleaning and repair work runs on Rotobrush and Nikro systems, the professional-grade equipment specified for duct cleaning rather than the consumer vacuums some crews bring. That matters for repair because a proper cleaning comes first: you can’t seal a joint you haven’t cleared of debris and dust. Whether you have a Honeywell setup, an Aprilaire cabinet, or any other make, we can help.
Signs You Need Duct Repair & Sealing Right Now
- Dust reappears within days of cleaning. If you’ve just had the ducts cleaned and dust settles on the furniture almost immediately, the system is pulling it in through a leak. Sealing the gap stops the source instead of chasing the symptom.
- One room never gets comfortable. A bedroom that stays cold in winter or hot in summer while the rest of the house is fine usually points to a disconnected or crushed run feeding it. That’s a repair problem, not a thermostat problem.
- Utility bills climb without explanation. When you haven’t changed your habits and the bill still goes up, escaping conditioned air is a likely cause. A leaky duct system means you’re paying to heat or cool the attic and crawl space along with your living room.
- A musty smell comes from the registers. Odor at the vents often means moisture is getting into the duct system through a gap or failed insulation. Closing that opening is the first step before any sanitizing work.
- Visible tears, kinks, or separated joints. If you’ve been in the attic or basement and seen flex duct pulled tight around a corner or a metal joint that’s come apart, don’t wait. A damaged run gets worse with every heating and cooling cycle.
Our Duct Repair & Sealing Process – Step by Step
- 1
Walk the whole system with you. We start by asking what you’ve noticed, then trace the ductwork from the air handler to the furthest register. Every joint, boot, and transition gets checked, including the runs that are hard to reach.
- 2
Clean before we repair. Using Rotobrush and Nikro extraction equipment, we clear the duct system so the surfaces we’re about to seal are actually clean. Sealant doesn’t bond to a dusty surface, and this step keeps debris from getting trapped behind a fresh joint.
- 3
Identify and mark every leak. We show you what we found rather than telling you. Leaks get marked so you can see the problem and understand what the repair involves before any work begins.
- 4
Repair and seal with the right material. Flex gets straightened or replaced, metal gets reseated, and every seam gets mastic and mesh. Where insulation is missing or torn, we restore it so the run stays efficient.
- 5
Verify airflow and walk you through it. We check airflow at the registers before we leave and show you before-and-after photos of the work. You’ll know what was fixed and why, not just that someone was in the attic.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in Sunset Park?
Duct repair and sealing in Sunset Park is priced per job by the written estimate, and the range depends heavily on how many leaks we find and how reachable they are. A small number of seam and joint leaks sealed with mastic typically runs a few hundred dollars. Replacing damaged flex runs or reseating separated metal sections adds material and labor. Restoring insulation on several runs in an unconditioned space costs more again. We don’t quote from the phone and we don’t give per-vent pricing, because both tend to produce a number that changes once the technician is in the attic.
What affects the price: the number of leaks, the length of duct involved, whether the damaged section is flex or metal, how accessible the runs are, and whether insulation needs replacing alongside the seal. What keeps you from overpaying is getting the repair included with a cleaning visit rather than calling out two separate contractors. A free estimate covers the system walkthrough, the leak identification, and a written price before any work starts. You agree to one flat price per system, and that’s the number on the invoice. If a quote seems dramatically cheaper than others, ask whether it includes sealing or just a surface pass.
Duct Repair & Sealing Near Sunset Park – Our Service Area
We cover Sunset Park and the neighborhoods around it, including Borough Park, Kensington, Bay Ridge, Dyker Heights, and Bensonhurst. We also work through Carroll Gardens, Red Hook, Park Slope, Flatbush, Midwood, and Prospect Heights. The rowhouse construction common across these blocks means duct runs are often short but tightly packed, so we plan for access before we arrive. Our duct repair & sealing work in Borough Park follows the same flat-price-per-job approach, and if you’re comparing options across neighborhoods, our duct repair & sealing page for Kensington covers the same scope. Dispatch runs from 7am to 7pm, Sunday through Friday.
Serving Sunset Park, NY – Our Local Coverage Area
We serve Sunset Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Duct Repair & Sealing in Sunset Park
Duct repair and sealing means fixing the physical damage and closing the gaps in your duct system so conditioned air reaches the rooms it’s meant to heat or cool. Repair covers torn flex, separated metal joints, crushed runs, and missing insulation. Sealing covers the smaller leaks at seams and boots using mastic and mesh. Both are done after a cleaning, so the surfaces being sealed are clean and the seal actually holds.
Most residential duct repair and sealing jobs finish in a single visit, often three to five hours depending on system size and how many leaks we find. A single damaged flex run is quick work. A whole-house sealing job with insulation restoration takes longer. We give you a time estimate with the written price before we start, so you know what your day looks like.
The price is set per job by a written estimate after we walk the system, and it depends on the number of leaks, the material involved, and accessibility. We don’t quote over the phone and we don’t charge per vent, because both produce numbers that don’t survive contact with a real attic. The estimate is free, and you see the full scope before you agree to anything. Call (844) 351-1795 for an exact quote – estimates are free.
Yes. We work with Honeywell and Aprilaire air quality components regularly and know how they mount to the ductwork and where their connections tend to leak. We handle the duct side of the system, resealing around filtration cabinets and humidifier tie-ins without disturbing the equipment itself. If you have another brand, we can still help with the ductwork.
Same-day repair is often possible when you call early in the day. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday, and we’re closed Saturday. A call outside dispatch hours gets booked into the next opening, so you’re never left guessing about when someone will reach out.
We stand behind the sealing and repair work we perform, and the written estimate spells out exactly what’s covered. If a joint we sealed fails, that’s on us to make right. Ask about the coverage for your specific job during the estimate so there’s no ambiguity on either side. The local pro we connect you with is licensed and insured as their state requires.
Clear access to your attic hatch, basement, and any closets housing ductwork or the air handler. Move fragile items away from those areas and make sure someone is home to let us in. If you have pets, a closed door on the work area helps. Beyond that, there’s nothing to do – the rest is our job, and we’ll walk you through what we found before the work starts. Our Air Duct Cleaning Sunset Park page covers what a cleaning visit involves if you’re pairing the two.
Schedule Your Duct Repair & Sealing Service in Sunset Park Today
Leaky ducts don’t fix themselves, and every season they run costs you money at the meter. Call (844) 351-1795 to schedule a free estimate in Sunset Park. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. One flat price per system, agreed before we start, with before-and-after photos so you know the work was actually done. If you’re due for a full cleaning first, start with duct repair & sealing and we’ll build the visit around what your system needs.
Written by the team at Air Duct Cleaning Sunset Park.